Technical information

Note: The display requires the 12 V batteries to be connected and a terminal change (stop and start vehicle via start/stop
button) to be carried out.
If the de-energised state cannot be identified by means of the instrument cluster (no message), the state can be identified
by a qualified electrical specialist with personal protective equipment via the following measurements.
.
Operations:
1. Switch off vehicle. Put vehicle in passive state via START-STOP button.
2. Remove vehicle key
3. Open tailgate.
4. Disconnect 12 V batteries.
.
Installation positions of the 12 V batteries
.
5. Pull apart the small connector (high-voltage service disconnect) at the high-voltage rescue separation point.
- On the right behind the luggage compartment trim panel (auxiliary battery)
- In the centre under the storage shelf (system battery)
Page
51
of
66
<!
----
>
2/24/2015
file://C:\Users\QX54891\AppData\Local\Temp\14\DW_Temp_QX54891\VUL
-
REL
-
BM
...