Technical information

off. The high-voltage system (IT system) consists of two separate circuits (HV+, HV-), which are completely decoupled
from the 12 V vehicle electrical system. The electrical GND (-) has no high-voltage potential. Only the housings of the
components are connected to GND to allow potential compensation. In order to provoke electrical damage, a person
needs to be in-between the positive and the negative HV circuit. If no damaged high-voltage cables (orange-coloured
lines) or high-voltage components are touched, an electric shock cannot occur under any circumstances.
Important: The instructions described in the following are intended for use exclusively on the BMW I01.
.
2 Essential information
2.1 Definition severely damaged vehicle
A vehicle is to be considered severely damaged if at least one of the following preconditions are met:
3 Rescue & Recovery
3.1 Securing the high-voltage system
The high-voltage system should be switched off by disconnecting the plug connection of the high-voltage emergency
separation point and by disconnecting the 12 V battery (negative terminal) (see emergency services card for
instructions). In case of airbag deployment, the switch-off of the high-voltage system can be assumed. Touching high-
voltage components and high-voltage cables is to be avoided. Ground straps (potential compensation) of the high-
voltage components may not be cut through. The de-energised state can be read off from the instrument cluster (12 V
battery must still be connected) or determined by a qualified electrician using defined measurements.
.
3.1.1 Deactivate the high-voltage system (switch to de-energised)
The high-voltage rescue separation point and the 12 V battery are located underneath the engine compartment lid.
The high-voltage system is to be deactivated by disconnecting the plug connection of the high-voltage rescue separation
point and by disconnecting the 12 V battery (negative terminal) (see emergency services card).
If the high-voltage rescue separation point underneath the engine compartment lid cannot be accessed, the switch-off of
the high-voltage system can also be carried out via the large high-voltage connectors at the electrical machine
electronics located in the luggage compartment underneath the service cap.
The high-voltage system can be switched off by removing (1) the small pole connector. See following chapter, point 7.
.
3.1.2 Determine voltage free status
- Intrusions or deformation of more than 5 millimetres at the housing of the high-voltage battery
- Vehicle is completely or partially under water (for example harbour basin, river, channel system)
- Vehicle completely or partially on fire
Page
36
of
66
<!
----
>
2/24/2015
file://C:\Users\QX54891\AppData\Local\Temp\14\DW_Temp_QX54891\VUL
-
REL
-
BM
...