Product Manual

LED STATUS INDICATORS
BLINK EVERY FEW SECS
SOLID COLOUR
CONTINUOUS FLASH
NO LIGHT
LED STATUS KEY
CALIBRATION
Initialisation
pin in
The TrailSafe is in calibration.
Wait about 5 minutes until
the LED displays a solid
PURPLE.
Completed 1st calibration stage. Remove the pin.
Initialisation
pin out
The pull pin is out when calibration
starts.
Put the pull pin back in and
wait for 1 minute, or power
cycle the unit to restart
calibration.
The TrailSafe is in calibration.
Wait about 1 minute until
the LED displays a solid
PURPLE.
Completed 2nd calibration stage. Put the pin back in.
The wiring voltage drop is
exceeding 10% of the nominal
voltage. The LED will flash both
purple and red.
Check wiring and
connections and consider
increasing the wire size.
The pull pin was removed
before the calibration stage was
completed. The LED will flash both
purple and orange.
Put the pull pin back in to
restart.
Initialisation
complete
The TrailSafe has finished
calibrating, and is calculating
battery capacity.
Wait for the LED to move to
standby mode. The LED may
stay orange for some time,
or may move to standby
mode very quickly.
CONDITION
STATUS SOLUTIONSTATE
16