Product Manual

WARNING
The green wire must be connected to a battery positive terminal when a LiFePO4
battery is used. Failure to do so may result in false battery capacity information.
Failure to install the fuse may result in permanent and serious
failure or damage to the TrailSafe and/or the wiring.
WARNING
TRAILSAFE+
RED (14AWG / 2.5mm2) Connect to the positive of the brake lights.
BLUE (12 AWG/ 4 mm2) Connect to the positive of the brakes.
PURPLE (14 AWG/ 2.5 mm2) Connect to a remote voltage monitor.
WHITE (14 AWG/ 2.5 mm2) Connect to the negative of the house battery.
BLACK/RED (12AWG / 4mm2)
Connect to the positive of the house battery (30A fuse
required).
GREEN (20AWG / 0.5mm2)
If using LiFePO4 Unconnected: connect to the positive
terminal of the house battery.
If using Lead Acid: connect to the negative terminal of the
house battery.
YELLOW (20AWG / 0.5mm2)
If SwayControl is being used, connect to the YELLOW
cable of SwayControl via connector.
If SwayControl is not being used, leave unconnected.
THIN RED (20AWG / 0.5mm2)
If SwayControl is being used, to the RED cable of
SwayControl via connector.
If SwayControl is not being used, leave unconnected.
NOTE: Larger wire sizes may be used. The minimum is shown.
For the black/red wire, a 30A automotive-grade fuse must be located as close to the
trailer battery as possible, but not before the battery charging source feed.
11