OWNER’S MANUAL TrailCheck TEAMBMPRO.
POWERING YOUR ADVENTURES With over 50 years’ experience in power solutions combined with manufacturing and design facilities in Melbourne, Australia, BMPRO are the leading experts in RV power and control management. Inspired by the great outdoors, we have created a range of rugged, smart and reliable products to power your adventures.
CONTENTS ABOUT TRAILCHECK Key Features What’s Included 4 4 4 TRAILCHECK MONITOR INSTALLATION INSTRUCTIONS 4 Pairing the TrailCheck to the TrailSafe Series 5 TrailCheck Status Indicator 6 SERVICING 9 SPECIFICATIONS 9 WARRANTY TERMS AND CONDITIONS MANUAL PART 034614 REV 1.
ABOUT TRAILCHECK TrailCheck is a wireless in-car monitor of towing safety equipment, which enables the status monitoring of: 1. BMPRO TrailSafe - emergency trailer breakaway safety system 2. BMPRO SwayControl - proactive electronic stability control (ESC) sway control system The TrailCheck will indicate system status with BLUE, GREEN, ORANGE or RED LED indicators. KEY FEATURES 9 Bluetooth connectivity. 9 LED status indicators for full-system safety check.
Apply the hook Velcro to the TrailCheck on the side to be attached to the vehicle by peeling off the clear tape. Similarly attach the loop side Velcro to the vehicle where it will be mounted so that the tapes will align. Ideally clean the surface with isopropyl (rubbing) alcohol and leave for 24 hours to achieve maximum adhesion before mounting the TrailCheck. Avoid contacting the tape with fingers. After completing installation of the TrailCheck, conduct a trial operation to check for faults.
TRAILCHECK STATUS INDICATOR Correct operation of TrailSafe and SwayControl should be checked prior to each use of the trailer. This check should be done prior to the trailer being hitched to the towing vehicle. TrailSafe can be checked by depressing brake or pulling out the safety pin.
House battery not detected or insufficient capacity for 15mins of emergency braking operation Charge or replace house battery. TrailSafe / TrailSafe+ in standby and house battery insufficient for 15mins of operation Charge or replace house battery. Pull pin out when calibration starts Put pull pin back in; wait for 1 minute or power cycle unit to restart calibration.
The indicators below are also available only for TrailSafe+ when used with SwayControl STATUS CONDITION SOLUTION Battery good for 15mins operation and SwayControl in normal operation Sway event active Battery may have insufficient capacity for 15 mins of braking operation or SwayControl not detected 1. Check battery to ensure over 10Ah battery capacity available. 2. Check if SwayControl is still connected.
SERVICING Do not attempt to service the TrailCheck yourself or dismantle, modify or repair the TrailCheck yourself; this will void your warranty. If your TrailCheck requires servicing, please consult your BMPRO dealer or visit teambmpro.com for assistance. SPECIFICATIONS TRAILCHECK SPECIFICATIONS Communications Bluetooth Low Energy (BLE 5.
WARRANTY TERMS AND CONDITIONS Registering your BMPRO product is an important step to ensure that you receive all the benefits you are entitled to. Please visit teambmpro.com to complete the online registration form for your new product today. 1. BMPRO goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for major failure and for compensation for any reasonably foreseeable loss or damage.
POWERING YOUR ADVENTURES. TEAM BMPRO .COM BMPRO +61 3 9763 0962 | sales@teambmpro.com 19 Henderson Rd, Knoxfield VIC 3180 Australia teambmpro.
