Product Manual

15
Final Brake Wiring Check and Start Up
To check that the SwayControl is wired correctly:
1. Refer to figure 10 to verify correct wiring on the left-hand side of the trailer.
Ensure that ONLY the PURPLE and WHITE wires from the SwayControl are
connected to the left side trailer brakes and are wired in parallel and not in series.
2. Refer to figure 10 on the following page and verify correct brake wiring on the
right-hand side of the trailer.
Ensure that ONLY the PINK and WHITE from the SwayControl wires are connected
to the right side trailer brakes and are wired in parallel and not in series.
After performing the final brake wiring check, the SwayControl is ready for start-up.
The operational status of the SwayControl is indicated by the LED Status Light. The
SwayControl is in sleep mode if the LED Status Light is off (dark). The SwayControl will
start-up (wake-up) when voltage is applied to the BLUE wire.
Once the trailer is connected to the tow vehicle, apply the manual override on the trailer
brake controller in the tow vehicle. If the SwayControl is installed correctly, the LED
Status Light should start flickering GREEN.
If the LED Status Light does not come on when applying the manual override on the
brake controller, refer to Troubleshooting with the Status Light to diagnose potential
faults in the installation of the SwayControl.