Product Manual
23
SMARTSENSE
The SmartSense propane gas sensor allows you to directly
monitor the levels of gas in a gas cylinder with ProSmart.
INSTALLING SMARTSENSE SENSORS
SmartSense sensors can be installed by following the
below instructions:
1. On the propane gas tank, ensure the base is clean.
Remove any debris, excess paint or rust.
2. Using the supplied grease, apply a generous amount to
the rubber pads on the back of the sensor.
3. The sensor mounts to the base of the tank using
magnets. The rubber pad between the magnets must
make good contact with the tank, with no contaminants
in between and must be aligned to the center of the
tank.
4. Return the tank to its upright position.
Ensure the tank is on a flat and level surface, or is otherwise level with ground.
Even a slight tilt can degrade the quality of the measurement. After a few
seconds, up to a few minutes, the propane will settle and the readings will
stabilise.
Installing SmartSense Sensors
SmartSense Propane
Gas Sensor