Operating Guide

17
To pair the ControlNode to your own personal mobile device:
1. Make sure that the ControlNode is connected to the J35 and that the J35 is
powered on.
2. Turn on Bluetooth on your own personal device
3. Press the Pairing Button on the ControlNode. The LED Status Indicator on the
ControlNode will flash green, indicating you have 30 seconds to pair to the
ControlNode.
4. Launch the JHub App and press scan at the prompt.
5. The JHub App will now search for nearby ControlNode devices and a pop-up
window will appear listing ControlNode devices available for connection.
6. Select the device with the number that corresponds to the last six digits of the
serial number of the ControlNode you wish to pair to.
For successful pairing, the LED Status Indicator on the ControlNode will turn off
and the Bluetooth Connectivity icon in the JHub App will turn blue.
PAIRING WITH THE CONTROLNODE
A ControlNode can simultaneously pair to five mobile devices (including the JHub Tablet). If
the ControlNode is already paired to and in Bluetooth range with five mobile devices, the LED
Status Indicator on the ControlNode will flash orange for one second.
Press and hold the Pairing Button on the ControlNode for 10 seconds until the LED flashes
red. This will clear the ControlNode memory of any connected devices. The ControlNode will
then automatically flash green to indicate that it’s ready to pair with a new mobile device.
When you clear the memory on the ControlNode, the Bluetooth connection to all mobile
devices paired to but not in Bluetooth range with the ControlNode will be lost. To use the
JHub App on these devices again, these devices will need to be re-paired.