Operating Guide

11
ControlNode
Figure 2: The ControlNode
1
3 2
q PAIRING BUTTON
Button to enable Bluetooth pairing between the ControlNode and the JHub App
on your own personal mobile device or JHub Tablet.
w LED STATUS INDICATOR
Indicates the operational/pairing status of the ControlNode.
Table 5: ControlNode Operational Status and LED Flash Codes
*After memory has been cleared, the ControlNode LED Status Indicator will immediately flash green
to enable pairing to a new mobile device.
Operational Status Flashing Status Note
ControlNode is ready to pair Green Flash 30 sec
ControlNode memory is full, cannot
pair to any new mobile devices
Orange Flash 1 sec To pair to a new mobile device, clear
the memory of the ControlNode
Clearing ControlNode memory* Red Flash 1 sec Memory will only be cleared if the
user presses and holds the Pairing
Button for 10 seconds.
e CONTROLNODE SERIAL NUMBER
Required to choose the correct device when pairing the ControlNode to the JHub
App on your own personal mobile device or JHub Tablet.