Getting Started Guide

base station antenna, the lower the power output. Before a phone model is

available for sale to the public, it must be tested and certified to the FCC

that it does not exceed the limit established by the government adopted

requirement for safe exposure. The tests are performed in positions and

locations (e.g., at the ear and worn on the body) as required by the FCC for

each model. The highest SAR value for this model phone when tested for

use at the ear is 1.131W/Kg and when worn on the body, as described in

this user guide, is 1.189W/Kg(Body-worn measurements differ among

phone models, depending upon available accessories and FCC

requirements). The maximum scaled SAR in hotspot mode is 1.189W/Kg.

While there may be differences between the SAR levels of various phones

and at various positions, they all meet the government requirement for safe

exposure. The FCC has granted an Equipment Authorization for this model

phone with all reported SAR levels evaluated as in compliance with the

FCC RFexposure guidelines. SAR information on this model phone is on

file with the FCC and can be found under the Display Grant section of

http://www.fcc.gov/ oet/fccid after searching on

FCC ID: ZSW-30-092 Additional information on Specific Absorption Rates

(SAR) can be found on the Cellular Telecommunications Industry

Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United

States and Canada, the SAR limit for mobile phones used by the public is

1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard

incorporates a sub-stantial margin of safety to give additional protection

for the public and to account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with

RF exposure requirements, a minimum separation distance

of 10mm must be maintained between the user’s body and the handset,

including the antenna. Third-party belt-clips, holsters,

and similar accessories used by this device should not contain any metallic

components. Body-worn accessories that do not meet these requirements

may not comply with RF exposure requirements and should be avoided.

Use only the supplied or an approved antenna.