Instructions
- 3 - - 4 -
is detected within the camera’s eld of vision. When all movement ceases, the re
-
cording will stop after 10 seconds and be saved. Should you stop any recordings
manually, or should the camera switch o, then the motion detector will deactivate.
-
Date stamp – Recordings are marked with actual times and dates.
-
Record audio – The microphone can be switched on and o here.
-
G-sensor – If the G-sensor iss activated, then, in case of any collision, it will auto-
matically lock the current recording and protect against it being overwritten. It is
possible to set the sensitivity on three levels (8G = the most sensitive).
Camera Settings
- Resolution – VGA up to 12 megapixels.
-
Quality – Fine, Normal and Economy.
-
Exposure – Controls the brightness of the screen (the higher the number, the bright-
er the screen).
-
Quick view – Once a photograph is taken, it will remain on the display for a few
seconds to allow the viewer a brief check.
-
Date stamp – Photographs are marked with the time and date.
System Settings
- Date/time – The time and date can be altered by the Up/Down buttons. This can
then be set by pressing OK.
-
Auto power o – When activated, the camera will switch o after 1 to 3 minutes
of inactivity.
-
Screen o – When activated, the display will switch o after 3/5/10 minutes of ina-
ctivity. This also occurs when the camera is recording. Pressing any button will turn
the display back on.
-
Key tone – Switch key tones on and o.
-
Language– Select the language for the system and any notications.
-
Frequency – Set the frequency for videos (Europe is 50 Hz).
-
Format – This will delete any data on the memory card.
-
Factory settings – This will restore all factory settings on the camera.
-
Firmware version – Shows the current rmware version.