Quick Reference Guide

HEX70HDU-KIT QUICK REFERENCE GUIDE
www.blustream.com.au | www.blustream.co.uk
02
TX Panel Description
1 Power status indicator
2 Local HDMI input signal link indicator
3 DisplayPort™ input signal link indicator
4 USB-C input signal link indicator
5 Remote (RX) HDMI input signal link indicator
6 Input / Auto select button - press to change source,
hold for 3 seconds to enable / disable auto signal
sense switching
7 IR control port (to Blustream 5V 3.5mm IR receiver or
IR control device)
8 IR IN (to Blustream 5V 3.5mm IR receiver)
9 IR OUT (to Blustream 5V 3.5mm IR emitter)
q RS-232 - 3-pin Phoenix connector for RS-232 pass
through, or device control by RS-232 commands
RX Panel Description
1
2
3
4
5 6
7
8 9
10
11
12
13 14 15 16 17 18 19
w USB Upgrade port
e HDBaseT™ output
r HDMI input - connect to source equipment
t DisplayPort™ input - connect to source equipment
y USB-C input - connect to source equipment
u EDID DIP switch (UP=0, DOWN=1)
i TCP/IP (RJ45) – connect to LAN for TCP/IP control
Default IP of the HEX70HDU-KIT is 192.168.0.200
o Reset HEX70HDU to default IP settings
p Power port – use included 24V/5A DC adaptor to
power the device
1 2 3
4 5 6 7
8
9
10
11
12 13 14 15 16
1 Power status indicator
2 Local HDBaseT ™ input signal link indicator
3 Local HDMI input signal link indicator
4 Auto input signal link indicator
5 Input / Auto select button - press to change source,
hold for 3 seconds to enable / disable auto signal
sense switching
6 IR IN (to Blustream 5V 3.5mm IR receiver)
7 IR OUT (to Blustream 5V 3.5mm IR emitter)
8 RS-232 - 3-pin Phoenix connector for RS-232 pass
through, or device control by RS232 commands
9 USB Upgrade port
q HDBaseT™ input
w HDMI input - connect to local source equipment
e HDMI output - connect to display equipment
r Coaxial digital audio output – extract audio from the
selected input signal
t L/R analogue audio outputs (5-pin Phoenix)
extracted audio from the selected input signal.
Note: Input signal must be PCM 2ch audio
y Relay - 3-pin Phoenix connector
u Power port – Use included 24V/5A DC adaptor to
power the device