Manual

HEX31WP-TX USER MANUAL
04 www.blustream.com.au | www.blustream.co.uk
Front Panel Description
1 USB-C Input - Type C USB port to connect to USB-C source device
2 Output ON / OFF Button - Triggers the output on / o sequence (see Output On / O section on next page)
3 HDBaseT™ link status indicator - Illuminates when the Transmitter is connected to the Receiver / Matrix successfully
4 IR Receiver - Built in IR sensor for IR pass through
5 HDMI Input 1 - Type A HDMI port to connect HDMI source device
6 HDMI Input 2 - Type A HDMI port to connect HDMI source device
7 Auto Switching Button - Press to change source, hold for 3 seconds to enable / disable auto signal sense switching
8 HDMI Input 2 Indicator - Illuminates when HDMI 2 input is connected
9 USB Input Indicator - Illuminates when USB-C input is connected
q HDMI Input 1 Indicator - Illuminates when HDMI 1 input is connected
w RS-232 - 3-pin phoenix connector for RS-232 pass through to / from compatible HDBaseT™ Receiver / Matrix products
e 12V DC Input - 2-pin phoenix connector to connect to Blustream 12V power supply (supplied)
r IR Receiver Input - 3-pin phoenix connector to connect to Blustream IR Receiver (phoenix block supplied, IR Receiver
not supplied)
t HDBaseT™ Output - RJ45 HDBaseT™ port to connect to the HDBaseT™ input port of the compatible Blustream
HDBaseT™ Receiver / Matrix device
4 5 6 7
Rear Panel Description
21
8
10
9
3
1211 13 14