User manual

- 8 -
- 9 -
Blumax Bluetooth GPS-4013 Receiver
Charging your battery
For the 1st time you use the Blumax Bluetooth GPS-4013
Receiver, please charge battery until it is full. Take the pow-
er cable and connect it to the power jack (mini USB type)
and charge through car cigarette adaptor� This will begin to
charge the battery� Charging time is 3 hours typically�
The LED that represents the battery is the right-most battery
icon (shown in below)�
• If the LED is red, that means battery power is critically low.
Please charge�
• If the LED is green, that means battery is charging now.
• When the Power LED is off, the battery is fully charged.
When you plug into the mini USB cable to charge your unit,
it will take 5~10 seconds then you can see the green LED
turning on�
LED,
represents
the battery
status
Checking the package content
Thank you for purchasing Blumax Bluetooth Wireless GPS-
4013 Receiver with 66-Channels. It supports ultra high sen-
sitivity GPS navigation and supports Smart Power control
for power saving� Before you start using Blumax Bluetooth
GPS-4013 Receiver, please make sure if your package in-
cludes the following items� If any item is damaged or miss-
ing, please contact your dealer at once.
1. 1x Blumax GPS Receiver
2. 1x Li-ion rechargeable Battery
3� 1x Car charger
4. 1x CD-ROM (Manual+Software)
5. 1x USB to mini-USB cable
*Unit package contents may vary depending on countries
without prior notice�