Product Literature

Dimensions in millimeters (inch equivalents as noted) © 2019 Blum, Inc.
9
LEGRABOX
Attach drawer back
Rear fixing brackets are attached with #6 x 1/2" truss head screws
(612TH). The drawer back, with rear fixing brackets attached, snaps
into the rear of both drawer profiles.
Drawer bottom installation
The drawer bottom slides into the drawer profiles.
Push the drawer bottom flush with the front of the drawer.
Pre-bore and attach with wood screws (612TH).
Attach drawer front
Follow the installation drawing for locating hole positions for front
fixing brackets and pre-bore the necessary EXPANDO Ø10 x 12
holes (screw-on versions also available). Insert front fixing bracket
into pre-bored holes and screw as shown to secure.
Snap drawer front onto drawer.
Drawer box installation
Place drawer box onto cabinet profiles and insert drawer box
into cabinet.
Step 2
Step 3
Step 4
Step 5
Measure inside cabinet width (ICW)
Use inside cabinet width (ICW) to calculate the drawer bottom and
back dimensions. Formulas are found on the specification page of each
application.
M Height example:
Drawer bottom: Width
=
ICW minus 35 (1-3/8")
Length
=
Actual cabinet profile length minus 10 (13/32")
Drawer back: Width
=
ICW minus 38 (1-1/2")
Height
=
63 (2-15/32")
For best assembly results, use BOXFIX E-L.
Use 16 (5/8") material for drawer bottom and back
ICW
Drawer box removal
Pull drawer forward to reveal locking devices. Squeeze triggers on
locking device and lift drawer box off of runners.
Drawer Assembly and Removal
Step 1
NOTE: Minimum inside cabinet width without TIP-ON BLUMOTION = 148 (5-13/16")
Drawer Removal
A
B