TANDEMBOX Catalog

Dimensions in millimeters (inch equivalents as noted) © 2013 Blum, Inc.
81
Set mounting specifications
Top view
NOTE:
Orange dots indicate pre-mounted screw locations. All four screws are required to meet specified load capacities.
Important
Bin width and height must be considered
when designing your cabinet (see the
diagram on the left).
Drawer front attachment
Front view
A retainer or wood block should be added to the TANDEMBOX drawer to secure the bins and
keep them from pressing against the drawer front during daily operation
NOTE: Minimum opening height = 233 (9-3/16")
Drawer and cabinet specifications
Specifications
Waste/recycle set 356M55B7SAB 356M55B7SAD 356M55B7SAF
X 154.5 (6-3/32") 192.5 (7-19/32") 230.5 (9-1/16")
Z 146.5 (5-25/32") 184.5 (7-1/4") 222.5 (8-3/4")
minimum opening width 305 (12") 381 (15") 457 (18")
need bin height, not bin ht with
drawer.
Also need to find max opening
based on bin height
minimum top
clearance
6 (1/4")
16 (5/8") maximum
bott
om clearance depending
on cabinet bottom recess
opening width
opening height
maximum height
with bin =
opening height
minus 22 (7/8")
16 (5/8")
Minimum inside cabinet depth
With SERVO-DRIVE
574 (22-19/32")
Without SERVO-DRIVE
569 (22-13/32")
Cabinet bottom recess
6 (1/4") 3 (1/8") Flush
Y 16 (5/8") 19 (3/4") 22 (7/8")
417 (16-13/32")
45
(1-25/32")
37.5
(1-15/32")
559 (22")
minimum inside cabinet depth
4 (5/32")
Z
37.5
(1-15/32")
centerline of cabinet
96 (3-25/32")
64 (2-17/32")
32 (1-1/4")
X
Y + overlay
35 (1-3/8")