TANDEMBOX Catalog

Dimensions in millimeters (inch equivalents as noted) © 2013 Blum, Inc.
79
Required parts
Cutting dimensions for bottom and back
Drawer bottom
Minimum width
=
43 (1-11/16"") each
Length
=
actual cabinet profile length minus 24 (15/16")
Y = drawer bottom width minus (SW+63) divided by 2
Drawer back
Width
=
Y minus 12
then subtract 12
M height
=
84 (3-5/16")
D height
=
199 (7-13/16")
Y minimum
=
48 (1-7/8")
Y maximum
=
Trial recommended
AL = actual cabinet profile length
ICW = opening width
SW = width of the sink
Y = drawer bottom width of side 1 or 2 (variable)
Z = actual cabinet profile length minus 164 (6-7/16")
NOTE: Use 16 (5/8") material for bottom and back
A
B
A
B
Y-12
Y-12
Y
Y
SW 63
ICW - 75
AL - 24
M height 84
D height 199
+
ICW
Drawer front preparation
*Pre-boring dimensions for INSERTA and EXPANDO only, for screw-on pre-bore Ø2 x 2.5
Y + 44
32
32
Ø10 x 12*
Y + 44
15.5 + overlay
15.5 + overlay
Ø10 x 12* Ø10 x 12*Ø10 x 12*
47.5 min.
47.5
min.
+ overlay
Required outside drawer components (2 required per drawer)
M height required components
and specifications,
see page 16
D height with single gallery
required components and
specifications, see page 24
D height with design element
required components and
specifications, see page 36
D height with BOXCAP required
components and specifications,
see page 40
A B C D