TANDEMBOX Catalog

Dimensions in millimeters (inch equivalents as noted) © 2013 Blum, Inc.
77
Center adapter set
Set includes:
■
Left and right center adapter
■ Colors: gray
Part no.
Center adapter set
Z30N0002.6ZA
Inside drawer profile set
Set includes:
■
Left and right inside drawer profile
■ Drawer height 84 (3-5/16")
■ Colors: gray and stainless steel
NOTE: Additional rear bracket set required dependent on application (M height or D height)
nominal
length
actual cabinet
profile length
gray
stainless steel
20" 500 (19-11/16")
358M5004SG 358M5004IG
22" 550 (21-5/8")
358M5504SG 358M5504IG
Required outside drawer components
M height required components
and specifications,
see page 16
D height with single gallery
required components and
specifications, see page 24
D height with design element
required components and
specifications, see page 36
D height with BOXCAP required
components and specifications,
see page 40
1
2
Required parts
Rear fixing bracket set
3
Set includes:
■
Left and right bracket
■ Colors: gray and nickel
Rear fixing bracket set
Z30N000S.04
Installation screw
612TH
Cutting dimensions for bottom and back
Drawer bottom
Width
=
opening width minus 75 (2-15/16")
Length
=
actual cabinet profile length minus 24 (15/16")
Y = drawer bottom width minus (SW
+
63) divided by 2
Drawer back
Width
=
Y minus 12
M height
=
84 (3-5/16")
D height
=
199 (7-13/16")
Y minimum
=
48 (1-7/8")
Y maximum
=
Trial recommended
AL = actual cabinet profile length
ICW = opening width
SW = width of the sink
Y = drawer bottom width of side 1 or 2 (variable)
NOTE: Use 16 (5/8") material for bottom and back
A
B
ICW
A
B
C
Y
Y
Y
140
SW - 86
SW + 63
- 12 Y - 12
M height 84
D height 199
ICW - 75
AL - 24
53
Z
Part no.
A B C D