Product Literature

Dimensions in millimeters (inch equivalents as noted) © 2019 Blum, Inc.
7
MOVENTO
Dimensions
Rear view
Drawers require Ø6 holes bored on each
side of the back panel to accept the hooks
on the back of MOVENTO runners
Installation
1
Position the Ø2.5 drill bit into the extension
chuck so that it will bore 10 (13/32") deep
2
Place template into the front corner of the
drawer
3
Bore two holes and repeat on other side
4
Attach locking devices with #6 x 5/8" deep
thread wood screws (606N or 606P)
NOTE: The mounting screws must go in at a precise angle and the locking device must fit flush to the drawer bottom to ensure proper
function of the complete drawer system
NOTE: Using the T65.1600.01 Concealed runner template is highly recommended
Boring
1
Place template over the drawer side
2
Position template so that the center rib rests
against the inside face of the drawer side
3
Set stop collar on Ø6 bit so that it will
bore 10 (13/32") deep
4
Hold template firmly and bore hole
5
Repeat on other side
NOTE: Using the T65.1600.01 Concealed runner template is highly recommended
Rear Notching
Locking Devices
Option – no notching
Make the back panel shorter and extend the
drawer bottom to the back of the drawer
Dimensions
Drawers must be notched in the back to
accommodate MOVENTO runners
The notches must be flush with the drawer
sides and bottom
Rear Boring
Concealed runner template
Ø6 bit with
stop collar
Ø2.5 bit with
extension chuck
Concealed runner template
75
°
Locking device
Screws
606N or 606P
page 34
7 (9/32")
11 (7/16")
Ø6 x 10
bore for hook
page 34
Drawer Preparation
50 (1-15/16") Minimum rear notch
13 (1/2")
Rear view
10
(13/32")