Specification Sheet

Dimensions in millimeters (inch equivalents as noted) © 2013 Blum, Inc.
33
Standard
One right and one left required per drawer
■ For use with standard applications
■ Captive right device and self-aligning left device
■ Self-adjusting drawer length tolerance
■ Zinc die-cast with synthetic, spring-loaded release levers
■ Minimum inside drawer width 124 (4-7/8")
■ Height adjustment
+
3 (1/8")
Part no.
Right locking device
T51.1801 R
Left locking device
T51.1801 L
Installation screw
606N or 606P
Vertical mount
One right and one left required per drawer
■ Vertical mount locking device used to minimize sub-front splitting
■ Captive right device and self-aligning left device
■ Self-adjusting drawer length tolerance
■ Zinc die-cast with synthetic, spring-loaded release levers
■ Minimum inside drawer width 124 (4-7/8")
■ Height adjustment
+
3 (1/8")
■ Minimum sub-front thickness 16 (5/8")
■ Designed for 13 (1/2") drawer bottom recess
Part no.
Right locking device
T51.1801.20 R
Left locking device
T51.1801.20 L
Installation screw
606N or 606P
Narrow drawer
One right and one left required per drawer
■ For use with narrow drawers
■ Maximum dynamic load capacity 25 lb
■ Captive right device and self-aligning left device
■ Self-adjusting drawer length tolerance
■ Vertical mount, two-piece nylon
■ Minimum inside drawer width 95 (3-3/4")
■ Height adjustment
+
3 (1/8")
■ Minimum sub-front thickness 16 (5/8")
■ Designed for 13 (1/2") drawer bottom recess
Part no.
Right locking device
T51.0801.20 R
Left locking device
T51.0801.20 L
Installation screw
606N or 606P
Without side adjustment