Installation Guide

Three-dimensional adjustment

Depth adjustment

Rotate rear spiral tech cam screw to adjust

door gap (+3 mm, -2 mm).

Side adjustment

Rotate front screw to increase or decrease

door overlay (±2 mm).

Height adjustment

Rotate cam screw on mounting plate to

adjust door position (±2 mm).

On non-cam mounting plates, loosen

screws, adjust door and retighten screws.

CLIP top BLUMOTION

LIT.HNG5100.08.10

PAGE 1
CLIP top BLUMOTION Three-dimensional adjustment Side adjustment Height adjustment Depth adjustment Rotate front screw to increase or decrease door overlay (±2 mm). Rotate cam screw on mounting plate to adjust door position (±2 mm). Rotate rear spiral tech cam screw to adjust door gap (+3 mm, -2 mm). On non-cam mounting plates, loosen screws, adjust door and retighten screws. Subject to technical modifications wihtout notice. © 2010 LIT.HNG5100.08.
PAGE 2
BLUMOTION deactivation Switch on hinge cup For small or light doors, the BLUMOTION can be deactivated on one of the hinges. Door must be closed once for the deactivation to be complete. To reactivate, move switch back to original position. 1 2 Blum, Inc. 800-438-6788 www.blum.com Subject to technical modifications wihtout notice. © 2010 LIT.HNG5100.08.