Installation Sheet

Rear side-to-side adjFront side-to-side adj
Level
Broken synchronization adapter
Rotate the rear
side-to-side
adjustment left or right to
re-align the back of the
drawer box with the front.
Rotate side-to-side adjustment left or right
equally on both locking devices. Drawer
front moves in the same direction as
rotation.
Check to ensure that the runners are
level, perpendicular to the face of the
cabinet, and parallel to each other.
If a synchronization adapter is broken, it can easily be replaced by simply
sliding another in its place.
To remove or insert the
synchronization rod, the pinions
must be put in the open position
by touching the drawer front or
runners to open them.
Rear tilt adjFront height adj
Square Rear notch
C l o s e d Open
To raise drawer
back/tilt front - Rotate
gray tilt adjustment
lever on the rear of
each runner.
To raise front - Press
up on adjustment
tab and push toward
back of drawer.
Check drawer box squareness,
either by measuring from inside
corner to inside corner, or by using a
framing square.
Measure the rear notches of the
drawer. Make sure they meet Blum’s
specifications.
View TIP-ON BLUMOTION section of
MOVENTO brochure for further instructions.
Drawer adjustmentsHelpful hintsFront gap template alternative Troubleshooting
If a front gap template is not present on the job site, a combination square can be used to set the
front gap. Please refer to the MOVENTO brochure for more information.
TIP-ON BLUMOTION depth adjustment with a combination square
Top view
763/769 (X = runner setback + 32 (1-1/4"))
769R (X = runner setback + 17.5 (11/16"))
1
x
x
Combination square
Cabinet face
Runner setback
+
-
+
-
2