Product Literature

Dimensions
Rear view
Drawers require Ø6 holes bored on each
side of the back panel to accept the hooks
on the back of TANDEM runners
Installation
1
Position the Ø2.5 drill bit into the extension
chuck so that it will bore 10 (13/32") deep
2
Place template into the front corner of the drawer
3
Bore two holes and repeat on other side
4
Attach locking devices with #6 x 5/8" deep thread
wood screws (606N or 606P)
NOTE: The mounting screws must go in at a precise angle and the locking device must fit flush to the drawer bottom to ensure proper
function of the complete drawer system
NOTE: Using the T65.1600.01 Concealed Runner Template is highly recommended
Dimensions in millimeters (inch equivalents as noted) © 2021 Blum, Inc.
11
TANDEM plus BLUMOTION
TANDEM plus BLUMOTION
Drawer Preparation
7 (9/32")
11 (7/16")
Ø6 x 10
Bore for hook
13 (1/2")
10
(13/32")
Boring
1
Place template over the drawer side
2
Position template so that the center rib rests
against the inside face of the drawer side
3
Set stop collar on Ø6 bit so that it will
bore 10 (13/32") deep
4
Hold template firmly and bore hole
5
Repeat on other side
NOTE: Using the T65.1600.01 Concealed Runner Template is highly recommended
Rear Notching
Locking Devices
Option – no notching
Make the back panel shorter and extend
the drawer bottom to the back of the drawer
Dimensions
Drawers must be notched in the back to
accommodate TANDEM runners
Rear view
The notches must be flush with the drawer
sides and bottom
13 (1/2")
35 (1-3/8") Minimum rear notch
Rear Boring
Concealed Runner
Template
Ø6 bit
with stop collar
Ø2.5 bit with
extension chuck
75
°
Locking device
Screws
606N or 606P
page 40
page 40
Concealed Runner
Template