Installation Instructions

Safety
RC66 | 08-2021Blum-Novotest GmbH
5
2. Safety
2.1 Intended use
The BLUM measuring component RC66 is exclusively developed and intended:
• For use within the machine room of a processing centre.
• For use within the machine room of a milling machine.
• for communication between the wireless measuring device and the interface.
• for use with one or more wireless BLUM measuring devices.
• for use with a BLUM Interface IF20.
• for use with a BLUM Interface IF59.
• for use with the BLUM software GeKo Programmiertool.
• for use with the BLUM software BLUM Bootloader.
• For installation by trained specialist personnel or a trained BLUM service employee.
• for operation by trained technical personnel.
2.2 Further applicable documents
• Measuring system data sheets (for any measuring devices, receivers, interfaces, extension modules and accessory
products involved).
• Measuring system operating instructions (as appropriate: measuring devices involved).
• Measuring system installation instructions (as appropriate: receivers, interfaces, extension modules involved).
• Wiring diagrams Wiring.
• Installation instructions SETUP (as appropriate: software, technology cycles involved).
• Programming instructions APPL (as appropriate: software, technology cycles involved).
• APPL instructions (if applicable, associated software – LC-VISION, BLUM Bootloader, GeKo programming tool, etc.).
• Documentation from the component manufacturer (any hardware involved – industrial PC, etc.).
• Documentation of the machine manufacturer.
• Documentation of the control manufacturer.