Technical data

50
51
This product has been built in accordance with IEC 60065 and left the
factory in safe working order. In order to maintain this condition and ensure
safe operation, the user must follow the advice and warnings in the
operating manual.
The device conforms to Protection Class 1 (protectively earthed). If this
product is used in vehicles, ships or aircraft or at altitudes exceeding 2000m
above sea level, make sure to follow the appropriate safety regulations,
which may exceed the IEC 60065 requirements.
WARNING: To avoid the risk of fire and electric shock, do not expose the
device to moisture or rain. Do not open the housing – no user serviceable
parts are contained inside. Must only be serviced by qualified service
personnel.
This symbol, wherever it appears, alerts you to the presence of
dangerous, uninsulated dangerous voltage inside the enclosure –
voltage that may be sufficient to constitute a risk of electric shock.
This symbol, wherever it appears, alerts you to the presence of
externally accessible dangerous voltage. External wiring connected to
any terminal marked with this symbol must be a pre-assembled cable
complying with the manufacturers’ recommendations, or must be wiring
installed by qualified personnel only.
This symbol, wherever it appears, alerts you to important
operating and maintenance instructions in the accompanying
literature. Please read the manual.
This symbol, wherever it appears, alerts you: Take care!
Hot surface! To prevent burns, do not touch.
The CE mark is a conformity marking that confirms compliance
with the valid EMC directive (2004/108/EG). The standards EN
61000-6-1, EN 61000-6-3 and the Low Voltage Directive
(2006/95/EG) with standard EN 60335-1 are also complied with.
This device complies with directive (2002/96/EG) WEEE. Appliance
must not be disposed of with household waste, but must be recy-
cled at the appropriate collection points for electrical and electronic
equipment/waste.
•Pleasereadtheseinstructions.
•Keeptheseinstructions.
•Thespecicationplateandtechnicaldatacanbefoundontheunderside
of the device.
•Followallwarningsmarkedontheproductandfollowallinstructionsin
this manual.
•Donotusethisproductnearwater.Donotplacetheproductnearwater,
bathtubs, washbasins, kitchen sinks, wet areas, swimming pools or damp
rooms.
•Donotplaceobjectsthatcontainliquidontheproduct(suchasvases,
glasses, bottles, etc.)
•Cleanonlywithadrycloth.
•Donotremoveanycoversorsectionsofthehousing.
•Toavoidtheriskofelectricshock,thegroundingofthisproductmust
always be maintained. Use only the supplied power cable, and always
maintain the function of the lateral grounded contacts of the mains
connection. Do not attempt to bypass the safety purpose of the grounded
plug.
•Protectthepowercablefrombeingwalkedonorsqueezed,particularly
near plugs, electrical sockets, and the point where they exit the device!
Power supply cables should always be handled with care. Check power
cables for cuts and signs of wear and tear at regular intervals, especially
around the plug and the point where the cable exits the device.
•Neveruseadamagedpowercable.
•Unplugthedeviceduringthunderstormsorwhenunusedforlongperiods
of time.
•Referallservicingtoqualiedservicepersonnel.Servicingisrequired 
when the unit has been damaged in any way, such as:
- When the power cable or plug is damaged or frayed.
- If liquid has been spilled or objects have fallen into the device.
- If the device has been exposed to rain or moisture.
- If the device does not operate normally when the operating instructions
are followed.
- If the device has been dropped or the housing has been damaged.
•Donotconnectexternalspeakerstothisproductwithanimpedance 
lower than the minimum impedance given on the product or in this
manual. Use only cables with an adequate cross section in accordance
with the local safety regulations.
•Neverexposethedevicetodirectsunlight.
•Donotinstallthedevicenearheatsourcessuchasradiators,heatex 
changers, ovens or other devices that produce heat.
•Donotblocktheventilationopenings.Installthedeviceinaccordance
with manufacturer’s instructions. The device must not be incorporated
into a built-in installation, for example a rack, unless proper ventilation is
provided.
•Allowthedevicetorestforatleastonehourafterithasbeenmovedfrom
cold to warm surroundings. Risk of condensation water inside the unit.
•Neverusethedevicenearopenre.
•Thedevicemustbeplacedatleast20cmawayfromwalls,mustnotbe
covered, and it must be ensured that at least 50cm of free air space is left
above the device.
Safety Instructions
CAUTION: When in Lead mode, extremely high gain and volume levels can cause strong feedback. Avoid this at all costs, as this may
cause hearing loss, and speakers may be damaged! For this reason, when operating at higher volumes, reduce the Gain, Treble and
Presence settings!
Important Safety Instructions! Please read before connecting!