Technical data

36
37
FOOTSWITCH / MIDI1 / REMOTE 20
Port for both conventional single or double footswitches, and also for REMOTE1
™
– the foot controller
that was specially designed to go with AMP1
™
– and the MIDI IN adapter MIDI1
™
. AMP1
™
automati-
cally detects which kind of footswitch or interface is connected! With a single footswitch, you can switch
between Clean mode and the Overdrive channel, which is available via the Overdrive selector switch 1.
With a double footswitch, the boost is also switchable.
When REMOTE1
™
and MIDI1
™
are connected, this jack port automatically becomes a serial data input
that controls all of AMP1
™
’s switching and control functions.
REMOTE1
™
or MIDI1
™
enable you (in conjunction with a MIDI controller) to switch the functions
CLEAN, VINTAGE, CLASSIC, MODERN, BOOST, REVERB, FX-LOOP, and additionally to control
MasterVolume and PowerSoak, as well as CLEAN VOLUME and GAIN. To connect AMP1
™
with
REMOTE1
™
, simply use a standard mono jack cable (for example a guitar cable or speaker cable).
NOTE: Apart from (passive) standard footswitches (with and without LED display), you may
exclusively connect the BluGuitar
®
REMOTE1
™
foot controller or BluGuitar
®
MIDI1
™
adapters
to this 6.3mm stereo jack port. Connection to another foot controller may cause defects to
this controller and/or to AMP1
™
’s internal electronics.
ATTENTION: The connecting cable should generally only be plugged in/removed when the
amp is switched off, in order to prevent faulty switching on the amp.
Configuration of the Remote stereo jack port
Jack GND
Jack Ring: Boost
Jack Tip: Kanal
FOOTSWITCH / MIDI1 / REMOTE & MIDI
36 37
MIDI1
MIDI CONTROL-CHANGE:
Master: CC 007
Gain: CC 020
PowerSoak: CC 030
MIDI RECEIVE CHANNEL: 1
128 Programm Change Befehle
MIDI Programm Change Nummer: 000 - 127
If you want to build an individual programmable guitar system using the MIDI controller of your choice, you
can control AMP1
™
using the BluGuitar
®
MIDI1
™
adapter interface.
This turns AMP1
™
’s remote port into a MIDI In port. This allows you to recall all of AMP1
™
’s switching
functions via MIDI program change commands. Additionally, control change commands CC 007 (Master-
Volume), CC 020 (Gain) and CC 030 (PowerSoak) are also received. You put MIDI1
™
’s adapter inter-
face’s port into AMP1
™
’s REMOTE port: on the opposite end is a 5-pin DIN socket for the MIDI IN. The
interface electronics are powered by AMP1
™
, meaning that no extra power supply or cables are required.
Every available switching possibility on AMP1
™
can be recalled via MIDI programm change commands,
when the corresponding command is sent from MIDI Channel 1. You can create up to 128 presets by
"MIDI-Learn" assigning.
Select your setting on AMP1
™
While the MIDI1
™
adapter is plugged in, MIDI-Learn is activated when holding the BOOST switch for a
few seconds. Now fast blinking of the REVERB LED indicates that AMP1
™
is waiting for MIDI programm
change command.
When sending any MIDI programm change command within the next 10 seconds, the setting is stored.
The REVERB Led stops blinking. Anytime this MIDI programme change command is send, AMP1
™
switches to the desired state.