Technical data

18
19
4
11 5
6
7 8 9 13
10
3
2
1
12
1 Overdrive Channel
Selection between Vintage , Classic and Modern
Pages 29-31
2 Nanotube
™
Sub miniature tube. Page 24
3 MasterVolume
Controls the overall volume of the 100-watt power amp.
Page 25
4 Clean Volume
Controls the Clean Channel’s volume and drive. Page 28
5 Overdrive Gain
The GAIN knob controls the input sensitivity – and therefore the
distortion – of the Vintage Classic and Modern Channels
Pages 29-31
6 Overdrive Master
Controls the overall volume of all three Overdrive Channels (Vintage,
Classic and Modern), Pages 29-31. To regulate volume and tone
between the three Overdrive Channels, use the CUSTOM CONTROL
™
Classic Volume 27 and Classic Tone 28, as well as Modern Volume 25
and Modern Tone 26.
7-9 Sound Control
To regulate cabs, space etc. Sounds most balanced in central positions.
If necessary, don’t be afraid of extreme settings!
Page 32
10 Reverb
Regulates the volume of the added reverb signal. The reverb is
modelled on the warmth and musicality of a classic spring reverb.
Page 33
11 Clean / Overdrive Channel
Here you switch between CLEAN and OVERDRIVE.
12 Boost on/off
The Boost switches a 2-level tube-like control in front of AMP1
™
’s
channels. You can control its intensity via 24. Page 33
13 Reverb on/off
Switches Reverb on and off.
You can allocate your favourite sounds and recall them directly with the
three integrated footswitches 11, 12 and 13. Page 39
AMP1
™
’s channels:
VOLUME determines the CLEAN Channel’s volume and drive. GAIN 5 controls the distortion, and MASTER 6 the volume of all three OVERDRIVE Channels.
MASTER controls the overall volume of the power amp and therefore the volume of all the sounds.
Control Panel