Users Manual

28 29
UP
Charging the battery outside of drone
1. Open lid.
Warning: We recommend charging the battery
inside the drone as much as possible to limit wear
of the o-rings on the aluminium lid.
> 1,5 m/s
150 m
2. Unscrew the aluminium lid with
the pin spanner to open it.
3. Pull out the battery.
4. Make sure that the charging selec-
tor switch on the bottom is set to
battery charging.
5. Remove the blue cover on charger.
Connect the power supply to
a wall socket and connect the
battery direcly to the back of the
charger.
6. Inspect o-ring for damages. Put a
small amount of silicone grease on
the o-ring before closing the lid.
7. Insert the battery. Make sure that
the arrow on the battery is point-
ing upwards.
8. Make sure that the battery is
pushed all the way in. There are
two guiding pins at the bottom of
the battery canister that will align
the battery with the connector.
Fold down the handle.
9. Close the aluminium lid with the
pin spanner. Make sure to not
tighten the lid too much, but there
shouldn’t either be a large gap
between the aluminium lid and
the aluminium tube. Be careful to
not damage the threads of the lid
when closing.
10. Close the battery lid by sliding it
along the battery tube. The battery
lid cannot be pushed all the way
in. Tightening the thumb screw will
move the lid into place.