Specifications

7
PT
Step 8: External battery connection (for long-run models only)
Before making external battery connection, please follow below steps to assemble battery
cable.
1
2
3
4
Suggest using AWG12 or 3
mm
2
fine-stranded, tip
bonded copper wires.
Supplied external battery
connector includes one
connector and one
connector housing
Open the connector
housing.
Put copper wires in cable
tie of housing.
5
6
7
8
There is a clamp in each
square hole of connector.
Push and hold the clamps
in connector with
screwdrivers (blade with
2.5mm).
After inserting stripped wire
as far as possible, release
the clamp. Then the wire
will be perfect locked in
connector.
Recommend to use 2 red
wires as “+”, 2 black wires
as “-“, and one green or
yellow wire as “GND”.
Clip the housing until latch
clicks.
9
Screw the housing to fasten
wires by screwdriver.
10
Suggest using rounded
terminal for external
battery wires.
Follow below chart to make external battery connection.