Operator`s manual
Connecting a Phono Player Using an External Preamp - 12
Connecting a Phono Player Using an External Preamp
NOTE: if your phono player does not have a built in preamp,
you will need to use an external pre-amp. (Not included)
If your turntable has a built in pre-amp and you don’t need to use an
external pre-amp, this page does not apply. Instead follow the directions
on connecting an Audio Input Device.
Using one of the supplied RCA cables, connect the red connector to the
right output of your pre-amp and the white connector to the left output
on the your preamp. On the other end of the cable, connect the red
connector to the right input of Aux 1 or Aux 2 on the BlueTube Audio
Amplier and connect the white connector to the left input of Aux 1 or
Aux 2 of the BlueTube Audio Amplier. Then
consult the users manual for the pre-amp
and phono player for instructions.