Use and Care Manual

35
Just Power On
11. Split Phase Function
Note:
(1) Please disconnect the AC charging cable for both EP500Pro units while
binding into split phase box.
(2) Certifcated Technician is required to build the split phase system to
power the Power Cabinet or Sub Panel.
Warning: If you insist to charge the EP500Pro which has been connected
into split phase box already, please make sure the L1/L2/N wire is set at
the right place or the EP500Pro will be damaged.
L: Live wire N: Neutral wire
●The “Machine Type” setting on screen is used to enable or disable Split
Phase output.Split-Phase output is achieved by bonding two EP500Pro into one
power system to double the available output power, voltage, and capacity.
●“Split Phase” is only used for connecting both *2 EP500Pro together (exclusive
for the 100-120V version of the EP500Pro). A Fusion Box(P30A) is required (sold
separately).
●Launch Split Phase Function:
Note: Only one touchscreen will be active when two EP500Pro units are
connected.
If one of the EP500Pro is out of power, the Split Phase Bonding function
will deactivate automatically.
Step 1: Plug the output cables from each of the two EP500Pro to the Split Fusion