User`s guide

4000/5000 Modems’ User Guide
Test
REG light on the modem should be flashing, indicating that the modem is
registered on the wireless network (in coverage)
Using BVDM, you can also read the modem’s diagnostic where received signal
strength (RSSI) is shown in bars and dBm
Æ You should have at least one signal bar or -98dBm
Another important parameter is the Ec/Io value available from BVDM >
Diagnostic > Advanced. BVDM shows the a numeric value that converts in dBm
by multiplying by -0.5.
Æ You should have at least -15dB
GPS antenna
If you’re using a 5200 or a 5600 modem model, it has an additional SMA connector for
the GPS antenna. The selected GPS antenna must meet the following specifications:
Active antenna with 3.3 volts preamplifier
Nominal 50 Ohms impedance
Male SMA connector
Frequency band: 1575 MHz
Revision 1.0 Copyright © 2004-2006 BlueTree Wireless Data Inc. Page 39 of 44