User`s guide

Appendix D : Dial-Up Networking in
Windows
This appendix shows how to create a dial-up networking session to access the Internet/cellular
network when connected to the modem using a serial cable. Although these instructions are
written for computers running Microsoft Windows XP, this procedure should be similar with
other versions of Microsoft Windows.
Installing a modem driver
1. Click Start > Run, type control modem.cpl and then click OK to open the Phone
and Modem Options panel
2. Click the Modems tab and then click Add
3. You may be required to enter location information if this is the first modem installed. If
this is the case, choose your region and area code in the information window.
4. Check the box labeled Don’t detect my modem… and then click Next
5. Select Standard 33600 bps Modem from the list and click Next
6. Select the COM port that the modem is attached to then click Next
7. Click Finish to complete the driver installation
Figure 36