User`s guide

2.1 Connecting to the modem
Should you run into any issues connecting to the modem, refer to the BlueVue Device Manager Troubleshooting appendix.
Click on Tools > Settings > Connection tab to select the interface your PC will use to connect to the modem.
Figure 4 – The different ways to connect to a modem
2.1.1 Using a serial cable:
1) Select Serial
2) Select the COM port in the dropdown list, then click OK
2.1.2 Using an Ethernet or USB cable:
3) Select Modem IP
4) Enter the appropriate modem IP then click OK. By default, the DHCP-assigned IPs will be 192.168.0.1 for Ethernet
and 192.168.111.1 for USB. If using USB, the BlueTree RNDIS driver must be installed as explained in the Data
Interface Specifications section.
2.1.3 Connecting to a remote modem:
5) Select Remote Configuration and click OK. A new panel will open to the left of BlueVue Device Manager.
6) Right-click Available Modems in the panel
7) Click Add…
8) Enter the modem’s information, then click OK. The description is optional.