User's Guide

Draft 1 BlueTree Wireless BT-4600/BT-5600 Product Manual 25
2. Connect the other end of the serial cable to an available
connection on your terminal.
Connecting the Ethernet data cable:
1. Connect one end the Ethernet cable to the modem at the
connector labelled ETHERNET.
2. Connect the other end of the Ethernet connection of your terminal.
Connecting the USB data cable:
This feature is not supported on product version 1.0
7) Configuring the modem
Once the physical installation is complete, the modem should be
configured for:
• Activation on the wireless network
• Operation mode and network connection setup
This configuration is performed using:
• BlueVue Device Manager companion software, or
• through standard AT commands (refer to AT Command manual).
8) Connecting to a wireless network using the serial
port (DB9)
Note: The following section is only required if you want to connect to
the network using a PC/laptop with Windows 2000/XP. It is
described here as an example of how a connection profile
should be configured to work with the BT4600/5600 modems.
Adding the modem
To add a modem in Windows 2000 or XP
1. Click Start > Settings > Control Panel > Phone and Modem
Options.