User's Manual
Table Of Contents
- FCC Compliance and Industry Canada Statement
- January 2005
- Chapter 1: Introduction
- Chapter 2: Product Description
- Available Models
- Front View
- Rear View
- Top View
- Bottom View
- LED indicators
- Serial Port (DB9)
- USB Port (Type B)
- Ethernet Port (RJ-45)
- Input and Output Ports (Digital & Analog I/O)
- Power Connector
- Chapter 3: Installation Requirements
- Cellular antenna
- GPS antenna
- Serial cable
- Ethernet cable
- USB cable
- Power source
- Mounting Hardware
- Wireless network account
- Chapter 4: Installing the Modem
- Power cable connector
- Powering up the modem
- Adding the modem
- Creating the DUN profile
- Chapter 5: Troubleshooting
- Appendix A: Warranty and Customer Support
18 BlueTree Wireless BT4400 & BT5400 Product Manual V0.0
USB Port (Type B) This feature is not supported on product version 1.0
Ethernet Port (RJ-45) The ethernet port of the modem is configured as shown in the
illustration below. The ethernet port is compliant to EIA-568 standard,
and requires a crossover cable to connect to host terminals.
Table 3: Ethernet connector pinout
A
Input and Output Ports
(Digital & Analog I/O)
This feature is not supported on product version 1.0
7 RTS Request To Send PC to Modem
8 CTS Clear To Send Modem to PC
9 RI Ring Indicator Modem to PC
Pin number Name Description Direction
Pin number Name Description Direction
1 TX+ Transmit + Modem to PC
2 TX- Transmit Modem to PC
3 RX+ Receive + PC to Modem
4 N.C. None None
5 N.C. None None
6 RX- Receive - PC to Modem
7 N.C. None None
8 N.C. None None
Picture
Paste
Here