Operation Manual

CONNECTIONS (MA900-MA1200)
. Parallel (Mono) Mode
To put the amplifier in parallel-mono mode, first turn ttie amplifier off, then sli
"PARALLEL (MONO)" position and properly connect the input/output wiring as s
(Note: Do not connect a speaker load less than 4 ohms as it can damage your amplifier.)
[Note: Do not use the "PARALLEL (MONO)" switch when feeding the arnp 2 separate
MODE SELECTOR SWITCH (16) to the top
A signal into any input connector will drive both
. Bridged Mono Mode
To put the amplifier in bridged m
"BRIDGED" position and properl
channel "2" turned completely d
(Note: Do not connect a speak.
(Note: This mode produces a la
Page 16 Reference Manual