Instruction manual

• When the speaker is ON the Power/Signal LED Indicator (11) will light
up.
5. Press the TUNE button (9) on the front of the Speakers or on the Remote (17)
and the Speakers will automatically connect to the Transmitter. This may
take a few seconds.
6. Press Play (if necessary) to start music playback on the connected audio
source (MP3 player, DVD player etc.) and hear the audio from the speakers.
USING THE SPEAKERS INDIVIDUALLY (MONO)
1. Turn ON the audio source (MP3 player, TV, etc.) connected to the
Transmitter and the Transmitter Signal LED (2) will light up.
2. Select a channel by moving the Channel Selector Switch (4) on the Rear of
the Transmitter.
3. Set the Left/Mono/Right Selector Switch (13) on the bottom of each
speaker to “M” (Mono).
4. Press the POWER button (10) on each Speaker to turn the speaker ON.
• When the speaker is ON the Power/Signal LED Indicator (11) will light
up.
5. Press the TUNE button (9) on the front of the Speakers or on the Remote (17)
and the Speakers will automatically connect to the Transmitter. This may
take a few seconds.
6. Press Play (if necessary) to start music playback on the connected audio
source (MP3 player, DVD player etc.) and hear the audio from the speakers.
ADJUSTING THE VOLUME
1. The Volume can be adjusted on the speaker by pressing VOLUME UP (7) or
VOLUME DOWN (8) buttons.
2. The Volume can also be adjusted using the Remote by pressing the
VOLUME UP (16) or VOLUME DOWN (18) buttons. Point the remote directly
at the speakers. If the speakers are not close together you may need to point
the remote directly at each speaker if the speakers are not close together.
3. To Mute the sound from the speakers press the MUTE button (19) on the
Remote.
4. To un-mute the sound simply press the MUTE button (19) on the remote
again.