installation manual

INSTALLING CHIMNEY STYLE HOODS

1. Position the Chimney Hood on its back and

locate the transition inside the Chimney Hood;

remove the (4) #8 x ½” self tapping screws at the

top of the hood which hold the transition to the

hood (save these screws for later use), separate

the transition from the hood base and duct cover.

2. Install the transition to the duct work ensuring the

bottom of the transition is centered and flush with

the bottom of the duct cover. Check the position

of the transition by sliding the duct cover over the

mounted transition. Verify that the transition is

flush, and centered to the bottom of the duct

cover. When transition installation is complete,

be sure to check that the damper is not hindered

from opening if using mechanical fasteners. (See

Figure 5)

3. Run electrical supply from rear or top location of

hood to hood J-Box(See Figure 2)

4. Install the duct cover to the top of the hood using

the 12 – 24 self tapping 7/8” length screws. Also

bolt the hood to the duct cover using the supplied

stainless steel 3/8” bolts.

5. Before hanging the hood, drill holes in the back

of the hood, if necessary, to line up with the

structural studs in the wall. Also, be prepared

when hanging the hood to feed the electrical

either through the top down, or use the hole

provided in the back. You may drill a hole in the

back, if necessary, to accommodate the electrical.

(See Figure 2)

6. Slide the hood up the wall with the transition

sliding inside the duct cover, then secure the hood

to the back wall (drilling through the back of the

hood to locate studs). Use the #10 x 2” long self-

tapping screws to secure the hood to the wall

structure. (See Figure 6)

7. Once the hood is secure, attach the transition to

the rectangular plate at the junction of the hood

and duct cover with the screws that were

removed from the transition. (See Figure 6)