Owner's Manual

_Replacement
Parts-
When replacement parts
are
required,
be
sure the service technician
has used replacement parts specified by the manufacturer or have the same characteristics
as
the original part. Unauthorized substitutions may result
in
fire, electric shock,
or
other
hazards.
_
Safety
Check-
Upon
completion
of
any service
or
repairs
to
this product,
ask
the service
technician
to
perform safety checks
to
determine that the product is in proper operating
cond1t1on
.
_
Heat
- The product should be situated away from heat sources such
as
radiators heat
registers, stoves or other products (including amplifiers) that produce heat. '
Battery
shall
not
be
exposed
to
excessive
heat
such
as
sunshine,
fire
or
the
like.
Warning
To
reduce
the
risk
of
fire
or
electric
shock,
do
not
expose
this
product
to
rain
or
moisture
.
Caution
To
prevent
electric
shock,
match
wide
blade
of
plug
to
wide
slot,
fully
Insert.
Responsible
Party
Len brook America
6 Merchant Street
Sharon,
MA
02067
USA
Telephone:
800
263
4641;
781
784
8586
Facsimile:
781
784
8386
Warning
Changes
or
modifications
to
this
unit
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user's
authority
to
operate
the
equipment.
Note
This equipment has been tested and found
to
comply with the limits for a
Class
B digital
device, pursuant
to
Part
15
of the
FCC
Rules. These limits are designed
to
provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference
to
radio communications. However, there
is
no
guarantee that interference
will
not occur in a particular installation.
If
this equipment
does cause harmful interference
to
radio or television reception, which can
be
determined by
turning the equipment off and
on,
the user is encouraged
to
try
to
correct the interference by
one or more of the following measures:
_ Reorient or relocate the receiving antenna.
_
Increase
the separation between the equipment and receiver.
_ Connect
the equipment into
an
outlet
on
a circuit different from that
to
which the receiver
is
connected.
_ Consult
the dealer or
an
experienced radio/ TV technician for help.