User's Manual

Using the BSAP Command Line Interface (CLI)
BlueSecure™ Access Point 1800 Installation Guide 21
4. Enter the following username and password in lowercase at the displayed CLI
login prompts:
BlueAP login: adm1n (i.e., adm “one” n)
Password: blue1socket (i.e., blue “one” socket).
Navigating the BSAP CLI
The BSAP CLI main menu provides access to these options:
• Network Configuration - Configure the BSAP’s network settings including
its IP address and the IP address of the BSC to which it will connect.
• Save/Apply Configuration - After you have configured the BSAP’s
network settings, you must apply them before they become active.
• Restore Defaults - Restore the BSAP to its default settings.
• Show Version Information - Display BSAP version information.
• Reboot AP - After applying the BSAP’s configuration settings, you must
reboot the BSAP to effect the new configuration.
• Site Survey Configuration - In site survey mode, the BSAP beacons
known SSIDs on its 802.11a and 802.11 b/g radios operating at a
configurable power level and channel to facilitate a WLAN site survey.
Rebooting the BSAP following a site survey, restores the BSAP’s existing
configuration. See page 23 for details on using the BSAP’s site survey mode.
When operating in a submenu, press h to return directly to the main menu (or
home menu). Press p to return to the previous menu.
BSAP Default Configuration
The BSAP is shipped with the following default configuration.
IP_ADDR_MODE: DHCP (0)
Figure 19: PuTTY Configuration