User's Manual
Table Of Contents
- BlueSecure™ Access Point 1800 Installation Guide
- Overview
- Familiarizing Yourself with the BSAP Hardware
- Provisioning Your Bluesocket WLAN for BSAPs
- Selecting a BSAP Installation Location
- Mounting the BSAP
- Connecting and Powering the BSAP
- Using the BSAP Command Line Interface (CLI)
- General Specifications
- Declarations of Conformity and Regulatory Information
- Safety Warnings for BlueSecure™ Access Point 1800
Mounting the BSAP
BlueSecure™ Access Point 1800 Installation Guide 11
3. Slide the Trim Plates into the grooves of the BSAP-1800 unit as shown in
Figure 8. Slide each half of the trim plate until the halves click into place.
4. Turn BSAP-1800 unit over and place ceiling tile over the unit as shown in
Figure 9. The Trim Plates will aide in tiles correct position. Next attach the
Side Mounting Brackets to the Rear Mounting Plate using the 6-32 screws
with the external tooth washers attached.
5. Bring entire assembled kit (including tile) to suspended ceiling and attach
LAN cable into BSAP-1800 unit as shown in Figure 10. If cable is tight, shift
unit until cable has enough relief. After cable is wired in, place ceiling tile
back to desired location. The assembly may need to shift so trim plate will
cover all openings in the ceiling tile.
Figure 8: Trim Plate Installation
Figure 9: Side Mounting Bracket Installation