User's Manual
Table Of Contents
- BlueSecure™ Access Point 1800 Installation Guide
- Overview
- Familiarizing Yourself with the BSAP Hardware
- Provisioning Your Bluesocket WLAN for BSAPs
- Selecting a BSAP Installation Location
- Mounting the BSAP
- Connecting and Powering the BSAP
- Using the BSAP Command Line Interface (CLI)
- General Specifications
- Declarations of Conformity and Regulatory Information
- Safety Warnings for BlueSecure™ Access Point 1800
Mounting the BSAP
BlueSecure™ Access Point 1800 Installation Guide 9
7. Pencil
Mounting Kit Contents
The following figure depicts the contents of the mounting kit. Refer to the table
below the figure for a description of each numbered item shown in the figure.
Dropped Ceiling Kit Installation
1. Remove tile from suspended ceiling. Turn tile so you are looking at the back
side. Position the template provided, and tape it to the back of the ceiling tile.
Using a utility knife and a metal ruler, cut out the hole needed for the BSAP-
1800 unit. The cut-out tile should look like the picture below.
Figure 5: Mounting Kit Contents
Item Description Qty.
1 Ceiling Tile, Trim Plate 2
2 Rear Mounting Plate 1
3 Side Mounting Bracket 2
4 #6 x 5/16" Screw, Phillips Pan Hd 4
5 #6-32x1/4" Screw, w/Ext Tooth Washer
(Used only when mounting directly to ceiling)
4
6 #8x3/4" Sheet Metal Screws 4
7Plastic Anchors 4