User's Manual

20
- 3) Das dynamische Frequenzwahlverfahren dient insbesondere der
Vermeidung von Gleichkanalbetrieb mit Radarsystemen.
- 4) Bei Kanalbandbreiten < 20 MHz darf die mittlere spektrale
Leistungsdichte (EIRP/MHz) nicht größer sein als 3 mW pro 1 MHz bei
Systemen mit automatischer Leistungsregelung bzw. 1,5 mW pro 1 MHz
bei Systemen ohne automatische Leistungsregelung.
Greece
A license from EETT is required for the outdoor operation in the band 5470 to
5725 MHz. Bluesocket recommends checking http://www.eett.gr for more
details.
Italy
This product meets the National Radio Interface and the requirements specified in
the National Frequency Allocation Table for Italy. Unless this wireless LAN product
is operating within the boundaries of the owner's property, its use requires a
"general authorization." Please check with
http://www.comunicazioni.it/it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e
rispetta il Piano Nazionale di ripartizione delle frequenze in Italia. Se non viene
installato all'interno del proprio fondo, l'utilizzo di prodotti Wireless LAN richiede
una "Autorizzazione Generale". Consultare
http://www.comunicazioni.it/it/ per maggiori dettagli.
)
Note: Although Norway, Switzerland, and Liechtenstein are not EU member
states, the EU Directive 1999/5/EC has also been implemented in those countries.
)
Note: The regulatory limits for maximum output power are specified in EIRP
(radiated power). The EIRP level of a device can be calculated by adding the gain
of the antenna used (specified in dBi) to the output power available at the
connector (specified in dBm).
)
Note: Countries within the EU with restricted use of the ISM Band frequency range
include: CH, DE, DK, FR, FI, GB, IS, NO, NL, PT, SE, BE
Caution: 1. According to the standard of EN60601-1-2, clause 36.202.1 j, "The
EQUIPMENT or SYSTEM may exhibit DEGREDATION of performance (e.g. deviation
from manufacturer's specifications) that does not affect ESSENTIAL PERFORMANCE or
safety."
2. An ESD or EFT noise may cause this Wireless Access Point to time out for a few
seconds, but it will self-recover when ESD or EFT noise disappears. Therefore, to avoid
any safety concerns that may directly affect a patient's life, this access point is not
allowed to be used in patient-coupled or life-supporting equipment for data transmission.