Owners manual

MWS- 83MD
7
Ø Selecting the correct input to run the wire through can take some time and
experience. The general rule is to start in a much larger wire guide than the wire in
question, run the wire, check the wire. If not cut, step down to a smaller input guide
and try it again. It is a general misconception that the user should put a wire in the
hole that is the exact same size of the wire. This is rarely the case. After a while the
user will know from experience which guide is right for certain wire types.
WIRE TYPE GUIDE
Ø Sheathed flat cable: ≤ 0.55” (14mm) x 0.31” (8mm) WxH
Ø Twisted flat cable: ≤ 0.31” (8mm) x 0.23” (6mm) WxH
Ø Single-core cable: Dia. Φ0.07” (2mm) ～ Φ1” (25mm)
Round cable Sheathed flat cable Twisted flat cable Single-core cable
WIRE GUIDE DIAGRAM
RUNNING WIRE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Securing the machine and installing the hand-wheel and hand-crank or using a user
supplied chuck type drill to the 12mm drill shaft.
Ø Have your wires ready to process, by separating them by type and cutting them into
3-4’ lengths.
Ø Select a wire to strip.
Ø Decide on which guide is the correct guide input.