Owners manual

MWS- 808PMO
12
6. Use puller to pull bearing from cutter assembly. Make sure to mark the bearings position on
the steel rod to assure the correct position upon reassembly.
7. Unscrew spanner nut clockwise. If you do not have a spanner nut wrench, it is possible to
use a pair of vice grips.
8. MAKE SURE YOU MARK THE SPACERS 1 THROUGH 5 (OR 1 THROUGH 9 FOR THE TOP
ASSEMBLY), SO THAT THEY GO BACK ON IN THE SAME ORDER THAT YOU TOOK THEM
OFF.