Owners manual

MWS- 808PMO
8
Round cable Sheathed flat cable Twisted flat cable Single-core cable
WIRE GUIDE DIAGRAM
RUNNING WIRE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø After securing the machine, plug the machine into power source.
Ø Have your wires ready to process, by separating them by type and cutting them into
3-4’ lengths.
o This is primarily for safety, but also to protect the motor from torque created
by pulling heavy wires into the machine.
Ø Go through the on/off functions to make sure they are operating correctly. Start the
machine by pressing the green “on” switch. Stop the machine by pressing the red
“off” switch.
Ø Turn the machine on.
Ø Select a wire to strip.
Ø Decide on which guide is the correct guide input.
Ø Run the wire through.