Owners manual

MWS- 808D
9
Ø If using a drill and the drill shaft, slowly turn the drill forward causing the drill to turn
the lower roller shaft. After a comfortable speed is reached (slowly enough to have
power over the drill and control inputting wire safely) put a piece of wire in the
machine. Be cautious in the beginning to only use your drill as slowly as possible to
get a feel for how quickly the drill pulls the wire in. When in doubt, take your finger
off the power of your drill and regroup.
o If the wire did not cut through the complete jacket, run it through again
through a smaller channel.
o If there are no smaller channels, tighten the T-bolt half/full turn closest to the
channel you’re attempting to use.
Ø Separate the wire from the jacket
o On smaller wire this will be done by pulling the wire out of the jacket.
o For larger wires with thicker jackets, if you are not able to pull the wire out of
the jacket, you may need to run the wire through again cutting into the
opposite side of the wire jacket.