Owners manual
CG- 211C TORCH BURNER MACHINE
9
Ø Ensure the work surface and machine are free of debris, oil, etc.
o NOTE: The machine will deviate from the cut or potentially fall if the material is not clean
(bare) and seamless.
Ø Carefully place machine at the start of the cut ensuring the wheels gently make contact with the
cutting surface. If cutting pipe, it is generally easiest to start at the top of the pipe.
Ø Select appropriate size torch tips for the application. Install tip.
Ø Select cutting angle.
Ø Connect the control box cord connection plug.
o CAUTION: Ensure all power lines are run in a manner not to cross paths with cutting
flame or cut material work pieces.
Ø Securely fasten the plug into the machine and lock in using the plug screw.
Ø Select the neutral position in the machine directional toggle switch (center position).
Ø Plug the cord on the power control box into the external power source.
Ø Connect applicable gas lines.
o Make certain they are properly secured and there are no leaks. It is highly recommended
that leak testing be performed on the system prior to using the machine.
o Ensure the lines are long enough to complete the cut you are planning.
o ALWAYS use gas tank cylinders with properly outfitted regulators/flowmeters.
Ø Ensure the torch holder is not too close to the side of the heat guard. It should be set at least
4”s away from the side of the heat guard.
Ø Adjust the side knobs to raise the torch tip to a suitable level for lighting.
Ø Light the torch flame (see section below on proper lighting of torch flame).
Ø Adjust the side knobs a suitable level for cutting though the material.
Ø Select the drive direction using the toggle switch.
o CAUTION: If you have to change machine direction during cutting, please stop the
machine first by switching to the neutral position. Once it has fully stopped, switch
machine to new direction. This will avoid damage to the internal electrical components.
Ø Select the proper speed of the cut using the variable speed switch.
Ø Activate the toggle switch to engage the machine directionally.
Ø When the cut is complete, stop the machine switching the toggle switch to the neutral position.
Ø Turn the on/off switch on the power control panel to the “off” position.
Ø Shut off the torch flame.