Owners manual

CG- 211C TORCH BURNER MACHINE
8
o Make certain the inside if the torch holder is clean and does not have any burrs. Also
make certain any tips you use are free or burrs or defect. It is important the seats are
tight.
§ See section below on “proper lighting of gas torch”
o For straight cuts, ensure the torch holder is square (see figure below).
Ø Tighten the valve assembly side onto the main machine body to the left of the variable speed
switch. Ensure it is secured tightly to the body.
TRANSPORTING THE MACHINE
Ø When transporting the machine, always use the carrying handles on the sides of the machine.
Ø Disconnect the power control box from the main machine and transport separately.
Ø Ensure the torch tip is in a raised position so it will not get damaged when lifting up the machine
or putting down the machine.
Ø If transporting inside a vehicle, it is recommended to transport it on with the magnetic wheels
down so as to avoid the item falling over. It is also recommended to protect the wheels from
damage by placing on non-abrasive surface.
Ø DO NOT carry the machine by the cord.
Ø DO NOT allow the cords or plugs to drag along the floor when transporting.
RUNNING THE MACHINE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the work area.
o Consider the work surface material, condition, strength, density and rigidity. These
factors directly affect the tools use.
o WARNING: Ensure the piece being cut will be stable after the cut has been made.